To change the USRP device IP address, you must know the current address of the device, and you must configure the network.
Verify that your device is powered on and connected to your computer using the gigabit Ethernet interface.
Select
Start » All Programs » National Instruments » NI-USRP » NI-USRP Configuration Utility to open the NI-USRP Configuration Utility, as shown in the following figure.
Your device should appear in the list on the left side of the tab.
Select the
Devices tab of the utility.
In the list, select the device for which you want to change the IP address.
If you have multiple devices, verify that you selected the correct device.
The IP address of the selected device displays in the
Selected IP Address textbox.
Enter the new IP address for the device in the
New IP Address textbox.
Click the
Change IP Address button or press <Enter> to change the IP address.
The IP address of the selected device displays in the
Selected IP Address textbox.
The utility prompts you to confirm your selection. Click
OK if your selection is correct; otherwise, click
Cancel.
The utility displays a confirmation to indicate the process is complete. Click
OK.
Power cycle the device to apply the changes.
After you change the IP address, you must power cycle the device and click
Refresh Devices List in the utility to update the list of devices.
