Installing the Hardware

Install the NI-568x software before installing the hardware.
  1. Ensure that the NI-568x software is installed.
    Note If you connect the USB-5683 to a PC or chassis before installing the software, the PC or chassis does not recognize the USB-5683.
  2. Connect the A-Type USB connector to the PC or chassis and secure the Mini-B USB connector to the power meter using the anchor screw.
    Note The USB-5683 has a power requirement of approximately 450 mA. If you plan to use the device through a USB hub, NI recommends using an external power source.
Refer to the following figure for an example of a completed installation.
Figure 1. Installing the USB-5683

1378

  1. PXI Chassis
  2. USB Cable
  3. Mini-B USB Port
  4. Mini-B USB connector
  5. NI RF Power Meter Back Panel