Installing Software on the sbRIO-9607

Complete the following steps to install software on the sbRIO-9607.

1. In MAX, expand your system under Remote Systems.
2. Right-click Software.
3. Select Add/Remove Software to launch the LabVIEW Real-Time Software Wizard.
   Tip You must log in if you set a system password.
4. Select the recommended software set for your LabVIEW and NI CompactRIO Device Drivers versions.
5. Click Next.
6. Select NI Scan Engine from the software add-ons.

   Select any additional software to install. If you plan on using the sbRIO-9607 with the LabVIEW FPGA Module, you can click Next.

   Tip You can use this wizard at anytime to install additional software.
7. Click Next.
8. Verify that the summary of software to install is correct.
9. Click Next to start the installation.
10. Click Finish when the installation is complete.