Common Configuration Utility Actions and Default Values

Refer to the tables below for common Configuration Utility actions and default values.

Table 44. Common Configuration Utility Actions
Action Procedure
New configuration File » New or click Ctrl + N
Open a file File » Open File or click Ctrl + O
Change folder Click the working directory bar or click File » Open Directory
Edit settings Select a node in Sections, then edit fields in the Editor
Add all hardware Hardware » Add All Discovered
Add one device Hardware » Add VST or

Hardware » Add Coprocessor

or

Hardware » Add AATT
Add by hand Hardware » Add Manual
Associate an attenuator Drag the AATT node onto a VST node
Remove a device Hardware » Removed Selected or right-click and select Remove from the drop-down menu
Save File » Save or click Ctrl + S
Make this the default File » Make Default
Show advanced fields Options » Development Mode
Table 45. Common Configuration Utility Default Values
Operation Default Value
Default configuration file %PUBLIC%\Documents\National Instruments\RTG\RTG Configuration Support.ini
Development Mode at launch Off
New file content Minimal section set