What to Use

  • Current transducer
  • SHDB9M-DB9F-BNCM cable

What to Do

Complete the following steps to connect current transducers to the RM-26999.

Figure 17. Connecting Current Transducers for Voltage Output


  1. Power off the RM-26999 and the system you are connecting to the RM-26999 for measurement.
    Caution You must de-energize the system before you connect it to the RM-26999 for measurement. Follow all workplace safety requirements for powering down hazardous voltage systems based on the applicable codes and standards in your location.
    Attention Vous devez mettre le système hors tension avant de le connecter au RM-26999 pour prendre des mesures. Respectez toutes les exigences de sécurité sur le lieu de travail concernant la mise hors tension des systèmes à tension dangereuse en fonction des normes et des codes locaux en vigueur.
  2. Connect the BNC connector on the SHDB9M-DB9F-BNCM cable to the BNC port on the transducer.
  3. Connect the female DSUB connector on the SHDB9M-DB9F-BNCM cable to the DSUB port on the transducer. Secure the connector by tightening the retention screws.
  4. Connect the male DSUB connector on the SHDB9M-DB9F-BNCM cable to the transducer port on the RM-26999. Secure the connector by tightening the retention screws.
  5. Power on the RM-26999 and the system you are connecting to the RM-26999.
  6. Verify that the corresponding CT Status LED is on.