Specifies the source of the pulse modulation signal. When Pulse In in used, the pulse modulation is applied with the lowest latency and jitter, but is not aligned to any particular waveform sample. When a marker is used, the RF pulse is aligned to a specific sample in the arbitrary waveform. To set this property, the NI-RFSG device must be in the Configuration state.

Supported Devices: PXIe-5842

Default Value: PulseIn

Remarks

The following table lists the characteristics of this property.

Short Name Pulse Modulation Source
Data type cstr.png
Permissions Read/Write
High-level VIs N/A
Channel-based Yes
Resettable Yes
Do not drive signal

Do not drive pulse modulation.
PulseIn PulseIn

Use the PULSE IN terminal to drive pulse modulation of the signal.
Marker0 Marker0

Uses Marker0 to drive pulse modulation of the signal.
Marker1 Marker1

Uses Marker1 to drive pulse modulation of the signal.
Marker2 Marker2

Uses Marker2 to drive pulse modulation of the signal.
Marker3 Marker3

Uses Marker3 to drive pulse modulation of the signal.