Specifies whether the measurement detects the rising edge of a burst in the acquired waveform.

The detected rising edge of the burst is used for the measurement. If you are using an I/Q power edge trigger or a digital edge trigger to trigger approximately and consistently at the start of a burst, set this property to False. If you are unable to reliably trigger at the start of a burst, set this property to True.

You do not need to use a selector string to configure or read this property for the default signal instance. Refer to the Selector Strings topic for information about the string syntax for named signals.

The default value is False.

Remarks

The following table lists the characteristics of this property.

Short Name DSSSModAcc Burst Start Detection Enabled
Data type ci32.png
Permissions Read/Write
High-level VIs N/A
Resettable Yes
False 0

Disables detection of a rising edge of the burst in the acquired waveform for measurement.
True 1

Enables detection of a rising edge of the burst in the acquired waveform for measurement.