Sweep:Segment:Number of Segments

Specifies the number of sweep segments. This property is used only when you set Sweep Type property to Segment

If you increase this property value from N to N+K, then existing N segments are not affected but K new segments are added. If you reduce number of segments from N to N-K, then last K segments are deleted without affecting the remaining N-K segments.

You do not need to use a selector string to configure or read this property for the default signal instance. Refer to the Selector Strings topic for information about the string syntax for named signals.

The default value is 1.

Remarks

The following table lists the characteristics of this property.

Short Name	Num Segments
Data type
Permissions	Read/Write
High-level VIs	N/A
Resettable	Yes