RFmxSpecAn DPD Configure Apply DPD Configuration Input VI

Selector String specifies a selector string comprising of the signal name. If you do not specify the signal name, the default signal instance is used. The default value is "" (empty string).

Example:

""

"signal::sig1"

You can use the RFmxSpecAn Build Signal String VI to build the selector string.

Instrument Handle In specifies the RFmx session refnum. Instrument Handle In is obtained from the RFmxInstr Initialize NIRFSA VI.

Configuration Input specifies the mode of configuring parameters for applying DPD. The default value is Measurement.

Measurement (0)	Uses the computed DPD polynomial or lookup table for applying DPD on an input waveform using the same RFmx session handle. The configuration parameters for applying DPD such as the DPD DUT Avg Input Pwr, DPD Model, DPD Meas Sample Rate, DPD polynomial, and lookup table are obtained from the DPD measurement configuration.
User (1)	Applies DPD by using a computed DPD polynomial or lookup table on an input waveform. You must set the configuration parameters for applying DPD such as the DPD Apply DPD User DUT Avg Input Pwr, DPD Apply DPD User DPD Model, DPD Apply DPD User Meas Sample Rate, DPD polynomial, and lookup table.

error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

Instrument Handle Out passes a reference of your RFmx session to the next VI.

error out contains error information. This output provides standard error out functionality.