Specifies whether to use the configuration parameters used by the DPD measurement for applying DPD.

You do not need to use a selector string to configure or read this property for the default signal instance. Refer to the Selector Strings topic for information about the string syntax for named signals.

The default value is Measurement.

Remarks

The following table lists the characteristics of this property.

Short Name DPD Apply DPD Config Input
Data type ci32.png
Permissions Read/Write
High-level VIs N/A
Resettable Yes
Measurement 0

Uses the computed DPD polynomial or lookup table for applying DPD on an input waveform using the same RFmx session handle. The configuration parameters for applying DPD such as the DPD DUT Avg Input Pwr, DPD Model, DPD Meas Sample Rate, DPD polynomial, and lookup table are obtained from the DPD measurement configuration.

User 1

Applies DPD by using a computed DPD polynomial or lookup table on an input waveform. You must set the configuration parameters for applying DPD such as the DPD Apply DPD User DUT Avg Input Pwr, DPD Apply DPD User DPD Model, DPD Apply DPD User Meas Sample Rate, DPD polynomial, and lookup table. You do not need to call the RFmxSpecAn Initiate VI when you set the DPD Apply DPD Config Input property User.