Restores the NI-RFSA driver state to a default state to avoid RFmx using any hardware or driver state that was set by the RF toolkits or other custom NI-RFSA code.

Use this VI when you switch back to using RFmx to perform measurements after you have used the NI-RFSA handle to perform measurements with RF toolkits or you have used other custom NI-RFSA code. Unlike the RFmxInstr Reset to Default VI, the RfmxInstr Reset Driver VI does not reset RFmx properties configured on the RFmx session. Hence, you do not need to set RFmx properties again when switching back to RFmx measurements. Refer to RFmx SpecAn CHP - WCDMA ModAcc - CHP Example (LabVIEW) for more information about using RFmx to perform measurements.


icon

Inputs/Outputs

  • cgenclassrntag.png Instrument Handle In —

    Instrument Handle In identifies the instrument session. Instrument Handle In is obtained from the RFmxInstr Initialize NIRFSA VI or the RFmxInstr Initialize NIRFSA (Array) VI.

  • cerrcodeclst.png error in (no error) —

    error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

  • igenclassrntag.png Instrument Handle Out —

    Instrument Handle Out passes a reference of the instrument session to the next VI.

  • ierrcodeclst.png error out —

    error out contains error information. This output provides standard error out functionality.