Calibration

Returns an array to indicate which calibration steps contain valid calibration data. To omit steps with the valid calibration data from self-calibration, you can pass the Valid Steps parameter to the Steps To Omit parameter of the RFmxInstr_SelfCalibrate function. On a MIMO session, use the Selector String parameter to get the self-calibration validity for a specific MIMO port.

Self-calibrates the NI-RFSA device and associated modules that support self-calibration. If self-calibration completes successfully, the new calibration constants are stored immediately in the nonvolatile memory of the module. On a MIMO session, this function self-calibrates all NI-RFSA devices and associated modules that support self-calibration.

Self-calibrates all configurations within the specified frequency and reference level limits. If there is an open session for NI-RFSG for your device, it may remain open but cannot be used while this function runs. NI recommends that no external signals are present on the RF In port while the calibration is taking place. For more information about Self Calibrate Range, refer to the niRFSA Self Calibrate Range function topic for your device in the NI RF Vector Signal Analyzers Help. On a MIMO session, this function self-calibrates all NI-RFSA devices and associated modules that support self-calibration.