Groups

Group members

NameDescription
RFMXGSM_ATTR_AUTO_TSC_DETECTION_ENABLED

Specifies whether the measurement automatically detects the training sequence code (TSC).

RFMXGSM_ATTR_BAND

Specifies the operation band.

RFMXGSM_ATTR_BURST_SYNCHRONIZATION_TYPE

Specifies the method used to synchronize the burst.

RFMXGSM_ATTR_BURST_TYPE

Specifies the burst type.

RFMXGSM_ATTR_CENTER_FREQUENCY

Specifies the expected carrier frequency of the acquired RF signal. This value is expressed in Hz. The signal analyzer tunes to this frequency.

RFMXGSM_ATTR_EXTERNAL_ATTENUATION

Specifies the attenuation of a switch or cable connected to the RF IN connector of the signal analyzer. This value is expressed in dB. For more information about attenuation, refer to the RF Attenuation and Signal Levels topic for your device in the NI RF Vector Signal Analyzers Help.

RFMXGSM_ATTR_HB_FILTER_WIDTH

Specifies the filter width when you set the RFMXGSM_ATTR_BURST_TYPE attribute to HB.

RFMXGSM_ATTR_LINK_DIRECTION

Specifies the source of the signal to be measured.

RFMXGSM_ATTR_MODULATION_TYPE

Specifies the modulation scheme used for the signal.

RFMXGSM_ATTR_NUMBER_OF_TIMESLOTS

Specifies the number of time slots to be measured.

RFMXGSM_ATTR_POWER_CONTROL_LEVEL

Specifies the power control level corresponding to the transmitted power, as defined in section 4.1 of the 3GPP TS 45.005 v8.0.0 specifications.

RFMXGSM_ATTR_REFERENCE_LEVEL

Specifies the reference level that represents the maximum expected power of the RF input signal. This value is expressed in dBm for RF devices and Vpk-pk for baseband devices.

RFMXGSM_ATTR_REFERENCE_LEVEL_HEADROOM

Specifies the margin RFmx adds to the RFMXGSM_ATTR_REFERENCE_LEVEL attribute. The margin avoids clipping and overflow warnings if the input signal exceeds the configured reference level.

RFMXGSM_ATTR_RESULT_FETCH_TIMEOUT

Specifies the time to wait before results are available in the RFmxGSM Attribute. This value is expressed in seconds.

RFMXGSM_ATTR_SELECTED_PORTS

Specifies the instrument port to be configured to acquire a signal. Use RFmxInstr_GetAvailablePorts function to get the valid port names.

RFMXGSM_ATTR_SIGNAL_STRUCTURE

Specifies whether the signal is bursted or continuous. For bursted signal and continuous signals, set the RFMXGSM_ATTR_TRIGGER_TYPE to IQ Power Edge and None, respectively.

RFMXGSM_ATTR_TIMING_ADVANCE

Specifies the timing advance value as specified in the 3GPP TS 45.010 specification for GSM access burst.

RFMXGSM_ATTR_TSC

Specifies the training sequence code (TSC) to use. This attribute is applicable only when you set the RFMXGSM_ATTR_BURST_SYNCHRONIZATION_TYPE attribute to TSC and the RFMXGSM_ATTR_AUTO_TSC_DETECTION_ENABLED attribute to False. For access burst TSC0, TSC1, and TSC2 are applicable.

Attachments

None