Installing the PXIe-8246

Notice To prevent damage to the PXIe-8246 caused by ESD or contamination, handle the module using the edges or the metal bracket.
  1. Ensure the AC power source is connected to the chassis before installing the module.
    The AC power cord grounds the chassis and protects it from electrical damage while you install the module.
  2. Power off the chassis.
  3. Inspect the slot pins on the chassis backplane for any bends or damage prior to installation. Do not install a module if the backplane is damaged.
  4. Remove the black plastic covers from all the captive screws on the module front panel.
  5. Identify a supported slot in the chassis. The following figure shows the symbols that indicate the slot types.
    Figure 1. Chassis Compatibility Symbols

    1378

    1. PXI Express System Controller Slot
    2. PXI Peripheral Slot
    3. PXI Express Hybrid Peripheral Slot
    4. PXI Express System Timing Slot
    5. PXI Express Peripheral Slot
  6. Touch any metal part of the chassis to discharge static electricity.
  7. Place the module edges into the module guides at the top and bottom of the chassis. Slide the module into the slot until it is fully inserted.
  8. Secure the module front panel to the chassis using the front-panel mounting screws.
    Note Tightening the top and bottom mounting screws increases mechanical stability and also electrically connects the front panel to the chassis, which can improve the signal quality and electromagnetic performance.
  9. Cover all empty slots using EMC filler panels or fill using slot blockers to maximize cooling air flow, depending on your application.
  10. Connect an Ethernet cable to a GigE Vision camera, then connect the camera to the PXIe-8246 front panel.
  11. Power on the chassis.
    Note The first time you start the development computer after installing the hardware, allow several seconds for the drivers to load.