1. Gently insert the guide pins and the high-density card edge of the FlexRIO adapter module into the corresponding connectors of the FlexRIO FPGA module, as shown in the figure below.
    Figure 5. Installing the FlexRIO Adapter Module


    1. FlexRIO Adapter Module
    2. Captive Screw
    3. Guide Pin
    4. PXI/PXI Express Chassis
    5. FlexRIO FPGA Module
    The connection may be tight, but do not force the adapter module into place.
  2. Tighten the captive screws on the FlexRIO adapter module to secure it to the FlexRIO FPGA module.
    NI recommends using the laser-tipped screwdriver (part number 748677-01) included in the PXIe-7975 packaging.
  3. Launch LabVIEW to begin configuring your FlexRIO system.