Notice To prevent damage to the NI 5624R caused by ESD or contamination, handle the module using the edges or the metal bracket.
Note

NI recommends installing the software before installing the hardware.

Before you install the hardware, refer to the guidelines in the Maintain Forced-Air Cooling Note to Users included with the module to ensure that the device can cool itself effectively. This document is also available at ni.com/manuals.

  1. Ensure the AC power source is connected to the chassis before installing the NI 5624R.
    The AC power cord grounds the chassis and protects it from electrical damage while you install the NI 5624R.
  2. Power off the chassis.
  3. Inspect the slot pins on the chassis backplane for any bends or damage prior to installation. Do not install the module if the backplane is damaged.
  4. If the chassis has multiple fan speed settings, ensure the fans are set to the highest setting.
    Note Inadequate air circulation could cause the temperature inside the chassis to rise above the optimal operating temperature for the device, potentially causing thermal shutdown, shorter lifespans, or improper performance.
  5. Position the chassis so that inlet and outlet vents are not obstructed.

    For more information about optimal chassis positioning, refer to the chassis documentation.

  6. Remove the black plastic covers from all the captive screws on the module front panel.
  7. Identify a supported slot in the chassis. The following figure shows the symbols that indicate the slot types.
    Figure 3. Chassis Compatibility Symbols


    1. PXI Express System Controller Slot
    2. PXI Peripheral Slot
    3. PXI Express Hybrid Peripheral Slot
    4. PXI Express System Timing Slot
    5. PXI Express Peripheral Slot
    The NI 5624R module can be placed in PXI Express peripheral slots or PXI Express Hybrid peripheral slots.
  8. Touch any metal part of the chassis to discharge static electricity.
  9. Ensure that the ejector handle is in the downward (unlatched) position.
  10. Place the module edges into the module guides at the top and bottom of the chassis. Slide the module into the slot until it is fully inserted.
    Figure 4. Module Installation


    1. Chassis
    2. Hardware Module
    3. Ejector Handle in Downward (Unlatched) Position
  11. Latch the module in place by pulling up on the ejector handle.
  12. Secure the module front panel to the chassis using the front-panel mounting screws.
    Note Tightening the top and bottom mounting screws increases mechanical stability and also electrically connects the front panel to the chassis, which can improve the signal quality and electromagnetic performance.
  13. Cover all empty slots using either filler panels (standard or EMC) or slot blockers with filler panels, depending on your application.
    Note For more information about installing slot blockers and filler panels, go to ni.com/r/pxiblocker.
  14. Power on the chassis.