PMC-GPIB Installation

Notice Electrostatic discharge can damage several components on your GPIB board. To avoid electrostatic damage when you handle the board, touch the antistatic plastic package to a metal part of your system chassis before removing the board from the package.
Complete the following steps to install your PMC-GPIB:
  1. Power off your system.
  2. Find an unused PMC slot in your system. You may need to remove the host from the system to access the PMC slot.
  3. Remove the corresponding slot filler panel from the host.
  4. Insert the PMC-GPIB into the slot as shown in the following figure. It might be a tight fit, but do not force the board into place.
    Figure 1. Installing the PMC-GPIB

    1378

    1 Host Face Plate

    2 3.3 V Keying Hole

    3.5 V Keying Hole

    4 PMC-GPIB Board

    5 Mounting Screws
  5. Use the mounting hardware provided to fasten the PMC-GPIB to the host.
  6. Reinstall the host, if you removed it to install the PMC-GPIB.
  7. Power on your system.

    The PMC-GPIB hardware installation is now complete.