RfsaAdvancedSignalPath Class
- Updated2025-10-14
- 2 minute(s) read
Provides advanced properties related to signal path.
Derives from
Syntax
Namespace: NationalInstruments.ModularInstruments.NIRfsa
public class RfsaAdvancedSignalPath : RfsaSubObject
Remarks
For more information, refer to NI RF Vector Signal Analyzers Help.
Properties
| Name | Description |
|---|---|
| AbsoluteDelay | Gets or sets the sub-sample clock delay, in seconds, to apply to the acquired signal. Use this property to reduce the trigger jitter when synchronizing multiple devices with NI-TClk. This property can also help maintain synchronization repeatability by writing the absolute delay value of a previous measurement to the current session. To set this property, the NI-RFSA device must be in the Configuration state. Note If this value is set, NI-TClk cannot do any sub-sample clock adjustment. |
| AvailablePaths | Returns a comma separated list of the configurable paths available for use based on your instrument configuration. |
| DownconverterLoopBandwidth | Gets or sets the loop bandwidth of the downconverter tuning phase-locked loops (PLL). |
| DownconverterPreselectorEnabled | Gets or sets whether the tunable preselector is enabled on the downconverter. |
| FrequencySettlingTime | Gets or sets the value used for LO frequency settling. |
| FrequencySettlingUnits | Gets or sets the delay duration units and interpretation for LO settling. |
| IFConditioningDownconversionEnabled | Gets or sets whether downconversion to 21.4 MHz is enabled for the IF conditioning module. |
| InputIsolationEnabled | Gets or sets whether input isolation is enabled. |
| InputPort | Gets or sets the connector(s) to acquire the signal. |
| LOFrequencyStepSize | Gets or sets the step size for tuning the local oscillator (LO) phase-locked loop (PLL). |
| LOInjectionSide | Gets or sets the LO injection side. |
| LOInPower | Gets the power level, in dBm, expected at the LO terminal when the LOSource property is set to LOIn. |
| LOOutPower | Gets or sets the power level, in dBm, of the signal at the LO OUT terminal when the LOExportEnabled property is set to true. |
| LOPllFractionalModeEnabled | Gets or sets whether to use fractional mode for the LO PLL. |
| LowFrequencyBypassEnabled | Gets or sets whether to use the low-frequency bypass path for the incoming RF signal. |
| NotchFilterEnabled | Gets or sets whether the notch filter is enabled on the RF conditioning module. |
| RFHighPassFiltering | Gets or sets the maximum corner frequency of the high pass filter in the RF signal path. |
| RFPreselectorFilter | Gets or sets the RF preselector filter to use. |
| SelectedPath | Gets or sets which path to configure to acquire a signal. |