Single-Point
- Updated2023-02-17
- 2 minute(s) read
Single-Point
Creates an XNET session at run time for the Frame Output Single-Point mode. This selection uses a PDU to specify the raw data, not a frame. Use the frame selections of XNET Write for the session, and access the payload array only.
Inputs/Outputs
PDU list
The array of XNET PDUs to read.
Your database specifies these PDUs.
interface
The XNET Interface to use for this session.
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
session out
The created session.
error out
Error information.
The node produces this output according to standard error behavior.