Enable Front End
- Updated2023-02-17
- 2 minute(s) read
Enable Front End
Enables the RF front end for the given channel. Use this node to toggle the active ATR state.
| Rx | Tx | ATR State |
|---|---|---|
| disable | disable | Idle |
| disable | enable | Tx only |
| enable | disable | Rx only |
| enable | enable | Full duplex |
Inputs/Outputs
niusrprio session in
Object created by the Open node and used as the session handle for the USRP RIO nodes.
enable
Signal that enables the device front end.
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
scope
Channel to operate on. Valid options are rx/RF 0, rx/RF 1, tx/RF 0, and tx/RF 1.
niusrprio session out
niUsrpRio session used in all subsequent USRP RIO host nodes.
error out
Error information.
The node produces this output according to standard error behavior.