Advanced Configure ATR Gain

Updates a specified ATR register state for advanced ATR gain configuration.

Inputs/Outputs

datatype_icon

scope

is the channel to operate on. Valid options are rx/RF 0, rx/RF 1, tx/RF 0, and tx/RF 1. For this node, scope is used to determine which daughterboard to update the ATR state of and whether to update the gain of Rx or Tx.

datatype_icon

atr register

The specific ATR register to write to.

The registers correspond to the four states each daughterboard supports. The daughterboard state is set based on whether Rx and Tx are enabled or disabled, using the Enable Front End node. It is safe to call the Enable Front End node after writing to the ATR registers.
datatype_icon

gain

The gain of the Rx or Tx signal. This gain is not coerced. Verify the input is in the daughterboard gain range.

datatype_icon

niusrprio session in

Object created by the Open node and used as the session handle for the USRP RIO nodes.

datatype_icon

niusrprio session out

The niUsrpRio session used in all subsequent USRP RIO host nodes.

datatype_icon

error in

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Default value: No error

datatype_icon

error out

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior