Configure Equalization Filter Coefficients

Configures the custom coefficients for the equalization finite impulse response (FIR) filter on the device.

The FIR filter is designed to compensate the input signal for artifacts introduced to the signal outside of the digitizer. Because this filter is a generic FIR filter, any coefficients are valid.

Note This node can be used only with high-speed digitizers that support onboard signal processing (OSP).
1378

Inputs/Outputs

datatype_icon

session in

Handle that identifies the NI-SCOPE instrument session as previously allocated by Initialize With Options .

datatype_icon

error in

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Default value: No error

datatype_icon

channels

The channel(s) from which to acquire data.

Channel String Syntax

This input parameter has the following syntax options:
  • A single channel, such as 0
  • A list of channels, such as 0,1 or 3,2,1,0
  • A range of channels, such as 0-7 or 0:7
  • A combination of channels from multiple instruments, such as PXI1Slot3/0,PXI1Slot3/2-3,PXI1Slot4/2-3
Note The order of channels in a list is important. The data for each channel is returned in the order the channels occur in the list.
datatype_icon

coefficients

The custom coefficients for the equalization FIR filter on the device.

These coefficients should be between +1 and -1. You can obtain the number of coefficients from the Equalization Num Coefficients property. The Equalization Filter Enabled property must be set to True to enable the filter.

datatype_icon

session out

Reference to the NI-SCOPE instrument session to pass to the next node in the program.

datatype_icon

error out

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior

Hardware Support

This node supports the following hardware:

  • PXI/PCI-5142
  • PXIe-5622