CableSense Signal Start

Generates the CableSense signal on all channels of an oscilloscope for which the signal is enabled, as configured by the CableSense Mode property.

Note The input impedance of the channel(s) to convey the CableSense signal must be set to 50 Ω.

You can call this node only during an acquisition. If you call this node while your oscilloscope is not acquiring, NI-SCOPE generates an error.

1378

Inputs/Outputs

datatype_icon

session in

Handle that identifies the NI-SCOPE instrument session as previously allocated by Initialize With Options .

datatype_icon

error in

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Default value: No error

datatype_icon

session out

Reference to the NI-SCOPE instrument session to pass to the next node in the program.

datatype_icon

error out

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior

Hardware Support

This node supports the following hardware:

  • PXIe-5110
  • PXIe-5111
  • PXIe-5113
  • PXIe-5160
  • PXIe-5162