Measurement:Maximum Frequency Span for Interpolation Property

Measurement:Maximum Frequency Span for Interpolation Property

Short Name: Max Freq Span for Interpolation

Property of niRFPM

Specifies the maximum span between two adjacent calibration frequencies for which interpolation will be performed, expressed in Hz.

This property does not support the mmWave subsystem.

Spans higher than 100 MHz are not supported and result in an error, and the driver does not accept the new value. Negative and zero spans are also not supported and result in an error, and the driver does not accept the new value.

Default Value: 20 MHz

Remarks

The following table lists the characteristics of this property.

Datatype
Permissions	Read/Write
High-level VIs	N/A
Channel-based	No
Port-based	No
Device-based	Yes
Resettable	No