niHSDIO Configure Sample Clock VI
- Updated2023-02-21
- 4 minute(s) read
Configures the Sample clock. This VI allows you to specify the Sample clock source and rate.
If clock source is set to On Board Clock, NI-HSDIO coerces the rate to a value that is supported by the hardware. Select Timing»Sample Clock»Rate from the niHSDIO Property Node to get the coerced value of the Sample clock rate. clock source can be set to Strobe only for acquisition sessions, or NI-HSDIO returns an error.
Refer to Clocks for Digital Waveform Generator/Analyzers for more information about the Sample clock sources. Refer to the Clocking book for your device for a block diagram of the clocking circuitry.
Related Topics
 |
instrument handle identifies your instrument session. instrument handle is obtained from the niHSDIO Init Acquisition Session VI, the niHSDIO Init Generation Session VI, or the niHSDIO Init Ext Cal VI. |
||||||
 |
clock source specifies the Sample clock source. You can select On Board Clock, ClkIn, PXI STAR Line, Strobe, or PXIe DStarA as the value for this control. |
||||||
 |
clock rate specifies the Sample clock rate, expressed in Hz. |
||||||
 |
error in (no error) describes error conditions that occur before this node runs. This input provides standard error in functionality.
|
||||||
 |
instrument handle out passes a reference to your instrument session to the next VI. instrument handle is obtained from the niHSDIO Init Acquisition Session VI or the niHSDIO Init Generation Session VI. |
||||||
 |
error out contains error information. This output provides standard error out functionality.
|
