Configure Sample Clock
- Updated2023-02-17
- 2 minute(s) read
Configure Sample Clock
Configures the Sample clock. This node allows you to specify the Sample clock source and rate.
If clock source is set to On Board Clock, NI-HSDIO coerces the rate to a value that is supported by the hardware. Select from the Propertynode to get the coerced value of the Sample clock rate. Only set clock source to Strobe for acquisition sessions, or NI-HSDIO returns an error.
Inputs/Outputs
session in
Instrument session obtained from the Initialize Acquisition Sessionnode, the Initialize Generation Sessionnode, or the Initialize External Calibrationnode.
clock source
The sample clock source.
You can select On Board Clock, ClkIn, PXI STAR Line, Strobe, or PXIe DStarA as the value for this control.
clock rate
The Sample clock rate, expressed in Hz.
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
session out
Handle that identifies the session in all subsequent node calls.
The session out parameter is obtained from the Initialize Acquisition Sessionnode or the Initialize Generation Sessionnode.
error out
Error information.
The node produces this output according to standard error behavior.