Adjust Offset Calibration
- Updated2023-02-17
- 2 minute(s) read
Adjust Offset Calibration
Calibrates the offset and Auto Zero offset for the specified parameters.
Refer to the calibration procedure for your DMM before using this node. The calibration procedure contains valid ranges and values for Funtion and Range.
Inputs/Outputs
session in
Instrument identifier from previous NI-DMM nodes.
Default value: None
function
Calibration mode used to acquire the measurement.
range
Range to calibrate.
Auto Range is not supported for calibration operations.
input resistance
Input resistance that the DMM uses, coerced up to the closest valid input resistance.
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
session out
Instrument identifier for subsequent NI-DMM nodes.
error out
Error information.
The node produces this output according to standard error behavior.