Create Source Waveform (Parallel)
- Updated2023-02-17
- 2 minute(s) read
Create Source Waveform (Parallel)
Sets the source waveform settings required for parallel sourcing.
Settings apply across all sites if multiple sites are configured in the pin map. You cannot reconfigure settings after waveforms are created.
Inputs/Outputs
data mapping
Parameter that specifies how to map data on multiple sites.
| Broadcast | 2600 | Broadcasts the waveform you specify to all sites. |
| Site unique | 2601 | Sources unique waveform data to each site. |
waveform name
The name to assign to the waveform.
Use the waveform name with source_start opcode in your pattern.
session in
Instrument session obtained from the niDigital Initialize with Optionsnode.
pin list
Source pins for the waveform.
The pin list must match the source pins in the pattern that references the waveform. The pin order in the pin list determines the bit positions of the data written by the niDigital Write Source Waveform node.
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
session out
Handle that identifies the session in all subsequent NI-Digital node calls.
error out
Error information.
The node produces this output according to standard error behavior.