Specifies the initial state of the Sequence Engine Done event if you set the Sequence Engine Done Event Output Behavior to Toggle Event Output.

Note This property is not supported by all devices. Refer to Supported Properties by Device for information about supported devices.

Default Value :Refer to Supported Properties by Device for the default value by device.

Note To specify a channel name when accessing this property, you must first initialize the session using the Initialize With Independent Channels VI.

Remarks

The following table lists the characteristics of this property.

Short Name Sequence Engine Done Event Toggle Initial State
Data type ci32.png
Permissions Read/Write
High-level VIs N/A
Channel-based No
Instrument-based No
Resettable No
Initial State Low 1149

The output is set to low at session commit. For operation in Single Point source mode, the output switches to high when the event occurs during the acquisition. The output then switches to low if a subsequent event occurs during the acquisition. This pattern repeats as events continue to be generated. For operation in Sequence source mode, the output switches to high the first time an event occurs during the acquisition. It then switches to low the second time an event occurs. This pattern repeats for any subsequent event occurrences.
Initial State High 1150

The output is set to high at session commit. For operation in Single Point source mode, the output switches to low when the event occurs during the acquisition. The output then switches to high if a subsequent event occurs during the acquisition. This pattern repeats as events continue to be generated. For operation in Sequence source mode, the output switches to low the first time an event occurs during the acquisition. It then switches to high the second time an event occurs. This pattern repeats for any subsequent event occurrences.