Specifies a limit for negative voltage slew rate, in volts per microsecond, for output cutoff. If the voltage decreases at a rate that exceeds this limit, the output is disconnected.

Syntax

NIDCPOWER_ATTR_OUTPUT_CUTOFF_VOLTAGE_CHANGE_LIMIT_LOW

Numeric Value

Data Type

Access

Applies To

1150238

ViReal64

Read/Write

Channels

Remarks


To find out whether an output has exceeded this limit, call the niDCPower_QueryLatchedOutputCutoffState function with NIDCPOWER_VAL_OUTPUT_CUTOFF_REASON_VOLTAGE_CHANGE_LOW as the

outputCutoffReason.

Note

NI-DCPower uses the terms "source" and "output". However, while sinking with electronic loads and SMUs these correspond to "sinking" and "input", respectively.

Note

This attribute is not supported by all instruments. Refer to Supported Attributes by Device for information about supported instruments.