Specifies a hysteresis level in the units of the measurement or generation. If Start.AnlgEdge.Slope is Rising, the trigger does not deassert until the source signal passes below Start.AnlgEdge.Lvl minus the hysteresis. If Start.AnlgEdge.Slope is Falling, the trigger does not deassert until the source signal passes above Start.AnlgEdge.Lvl plus the hysteresis. Hysteresis is always enabled. Set this property to a non-zero value to use hysteresis.

Remarks

The following table lists the characteristics of this property.

Short Name Start.AnlgEdge.Hyst
Data type cdbl.png
Permissions Read/Write
Resettable True
Settable While Task Is Running device-specific
Available in Run-Time Engine True