Installing Software on the NI-9147
- Updated2022-11-08
- 1 minute(s) read
Installing Software on the NI-9147
Complete the following steps to install software on the NI-9147.
- In MAX, expand your system under Remote Systems.
-
(cRIO-9032/9037) Update the firmware for your controller.
- Select the Systems Settings tab.
- Click Update Firmware.
- Select the latest firmware version.
- Click Open.
- Right-click Software.
-
Select
Add/Remove Software to launch the LabVIEW Real-Time Software Wizard.
Tip You must log in if you set a system password.
- Select the recommended software set for your LabVIEW and NI CompactRIO Device Drivers versions.
- Click Next.
-
Select
NI Scan Engine from the software add-ons.
Select any additional software to install. If you plan on using the NI-9147 with the LabVIEW FPGA Module, you can click Next. Click NI Scan Engine if you plan on using the NI-9147 without the LabVIEW FPGA Module.
Tip You can use this wizard at anytime to install additional software. - Click Next.
- Verify that the summary of software to install is correct.
- Click Next to start the installation.
- Click Finish when the installation is complete.