Write VI

Owning Palette: I2C VIs

Requires: myRIO Toolkit or roboRIO Toolkit

Writes data to an Inter-Integrated Circuit (I2C) slave device. This VI returns the result when finishing writing all the bytes or when timing out.

	Timeout ms specifies the number of milliseconds this VI waits for writing a single byte before timing out.
	I2C Ref In specifies the reference to the I2C channel. Use the Open VI to open a reference to the I2C channel. Do not modify the I2C Ref In values.
	Slave Address (7-bit) specifies the address of the slave device to which this VI writes data. You must specify the address in 7-bit. Some I2C devices might have a 8-bit address in which the first 7 bits represent the address and the last bit represents the mode of operation. For these kind of I2C devices, you must specify Slave Address (7-bit) using the seven most significant bits.
	Bytes to Write specifies the data to write to the I2C slave device.
	error in describes error conditions that occur before this node runs. This input provides standard error in functionality.
	Keep Bus Busy specifies whether to keep the I2C channel open so that you can perform additional operations. For example, if a slave device requires a write operation followed by a read operation to perform a command, you must set Keep Bus Busy to TRUE. The default is FALSE.
	I2C Ref Out returns the reference to the I2C channel that you specify.
	error out contains error information. This output provides standard error out functionality.