MT Demodulate PM
- Updated2023-02-17
- 4 minute(s) read
MT Demodulate PM
Performs phase demodulation on the incoming I/Q signal.
Inputs/Outputs
PM modulated waveform
The baseband (downconverted) time-domain data for demodulation.
t0
The trigger (start) time of the acquired signal.
Default value: 0.0
dt
Time interval between data points in the acquired signal.
Default value: 1.0
Y
The complex-valued time-domain data array. The real and imaginary parts of this complex data array correspond to the in-phase (I) and quadrature-phase (Q) data, respectively.
phase deviation
A value that indicates how to scale the PM demodulated waveform. You can set this value to 1.0 or to the expected phase deviation of the incoming PM signal for demodulation.
- Set this value to 1.0 to return a PM demodulated waveform in degrees with no scaling. In this case, the maximum amplitude of the PM demodulated waveform is equal to the actual phase deviation of the incoming PM signal.
- Set this value equal to the expected phase deviation of the incoming PM signal to divide the PM demodulated waveform by this value. You can use the resulting scaled PM demodulated waveform to quantify the degree of error between the expected phase deviation and the actual phase deviation.
carrier correction?
A Boolean that determines whether to enable carrier correction.
| TRUE | Determines a linear correction to the carrier frequency estimate and compensates for it in the FM demodulated waveform. |
| FALSE | Carrier correction is not enabled. Use this option when performing continuous acquisition. |
Default value: FALSE
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
reset?
A Boolean that determines whether initialization of an internal node state tracks the ending phase.
| TRUE | The node clears the state information about each call. |
| FALSE | The node uses the final phase from the previous call as the starting phase for the next call, ensuring phase continuity between calls. |
Default value: FALSE
PM demodulated waveform
The phase-demodulated information signal.
carrier offset
The offset, in hertz (Hz), between the incoming modulated carrier frequency and the estimated carrier frequency.
error out
Error information.
The node produces this output according to standard error behavior.
PM Demodulation
This node computes the information signal as a result of the demodulation and returns the data in the PM demodulated waveform.