Setting Up a System

Complete the following steps to set up a LabVIEW MIMO 5G/6G Research Design Library system:
  1. Install the PXI controller and modules into the PXI chassis on both the gNodeB and UE sides.
    Refer to the documentation of PXI instruments for installation instructions. Visit the NI Product Documentation Center for the latest documentation.
  2. Connect hardware components on the front side as the following figure shows.
    Figure 1. Hardware Connections on the Front Side

    Hardware Connections on the Front Side

  3. On both the gNodeB and UE sides, connect hardware components on the rear side as the following figure shows.
    Figure 2. Hardware Connections on the Rear Side

    Hardware Connections on the Rear Side

  4. On the OctoClock, set the PRIMARY REF switch to INTERNAL.