Writing a Data Break into a Citadel Trace
- Updated2025-11-07
- 1 minute(s) read
Use the Write Trace Break VI to insert a data break into a Citadel trace.
When you display Citadel data in a graph, the LabVIEW Datalogging and Supervisory Control (DSC) Module does not draw a line between two points separated by a data break.
Complete the following steps to insert a data break:
- Add the Write Trace Break VI on the block diagram.
-
Wire the trace reference output of the Open
Trace VI to the trace reference input of
the Write Trace Break VI.
Note If you close and then reopen a trace, the DSC Module automatically inserts a data break into the data stream, as if you had used the Write Trace Break VI.