SI Set Sampling Rate to System Model VI

Owning Palette: Model Management VIs

Requires: Advanced Signal Processing Toolkit or Control Design and Simulation Module

Applies a sampling rate to a system model. Use the SI Get Sampling Rate from System Model VI to retrieve the sampling rate from a system model.

	system model contains information about the model structure, nominal or estimated parameters, identification result, and so on. Note  You can use a customized system model probe to view model information that flows through system model wires when you debug a block diagram created with the System Identification VIs. Right-click a system model wire and select Custom Probe»SI System Model from the shortcut menu to use the system model probe.
	sampling rate (Hz) specifies the sampling rate to apply to system model. If system model is a continuous system, set sampling rate to a value less than or equal to 0.
	error in describes error conditions that occur before this node runs. This input provides standard error in functionality.
	system model out returns information about the model structure, nominal or estimated parameters, identification result, and so on.
	error out contains error information. This output provides standard error out functionality.