SI Get Names from System Model VI

Owning Palette: Model Management VIs

Requires: Advanced Signal Processing Toolkit or Control Design and Simulation Module

Reads input and output names from a system model. Use the SI Set Names to System Model VI to write input and output names to a system model.

Example

	system model contains information about the model structure, nominal or estimated parameters, identification result, and so on. Note  You can use a customized system model probe to view model information that flows through system model wires when you debug a block diagram created with the System Identification VIs. Right-click a system model wire and select Custom Probe»SI System Model from the shortcut menu to use the system model probe.
	error in describes error conditions that occur before this node runs. This input provides standard error in functionality.
	input names returns the names of the system model stimulus signals.
	output names returns the names of the system model response signals.
	error out contains error information. This output provides standard error out functionality.

Example

Refer to the Read Information from Model VI in the labview\examples\System Identification\Getting Started\General.llb for an example of using the SI Get Names from System Model VI.