Appends all samples from digital waveform B to the end of digital waveform A. If the sampling rates do not match, error out returns a warning. The start time of digital waveform B is ignored. Wire data to the digital waveform A input to determine the polymorphic instance to use or manually select the instance.


icon

Inputs/Outputs

  • cu8.png default value —

    default value specifies the value to use to fill in the extra signals of the digital data in digital waveform out if digital waveform A and digital waveform B do not have the same number of signals.

    00 (default)—Force Down
    11—Force Up
    2Z—Force Z
    3L—Compare Low
    4H—Compare High
    5X—Compare Don't Care
    6T—Compare Invalid
    7V—Compare Valid
  • cdigwdt.png digital waveform A —

    digital waveform A is the first set of data in the digital waveform.

  • cdigwdt.png digital waveform B —

    digital waveform B is the set of data to append to digital waveform A.

  • cerrcodeclst.png error in (no error) —

    error in describes error conditions that occur before this node runs. With the following exception, this input provides standard error in functionality.

    This node runs normally even if an error occurred before this node runs.

  • idigwdt.png digital waveform out —

    digital waveform out returns the waveform that results from appending digital waveform (low bits) to digital waveform (high bits). This output matches the compression of the input.

  • ierrcodeclst.png error out —

    error out contains error information. This output provides standard error out functionality.

    • Examples

    Refer to the following example files included with LabVIEW.

    • labview\examples\Controls and Indicators\Graphs and Charts\Digital Waveform Graph\Append Digital Data By Sample.vi