Returns the default position of the front panel window at run-time.

Parameters

Name Data type Required Description
Type ienum.png No

Returns whether the front panel is unchanged, centered, maximized, minimized, or has a custom setting.
Position inclst.png No

Indicates the top left coordinate of the front panel window position.
Size inclst.png No

Indicates the size of the window. For single-pane front panels, Size refers to the content area of that pane, not including the scroll bars. For multi-pane front panels, Size refers to the entire front panel, including any visible scroll bars. LabVIEW returns an error if you set the width or height to 0 or set the width or height less than the minimum window size.
Monitor ii16.png No

Specifies the monitor on which the front panel window appears, if you have multiple monitors. The value 0 is the primary monitor and is the default value. If you specify a value other than 0, the VI runs on that monitor. If you specify a monitor number greater than the number of monitors on the system, or if you specify a negative number, LabVIEW returns an error. The monitor number corresponds to the video card you plug the monitor in to.
Use Current Position ibool.png No

Returns the value of the Use Current Position checkbox in the Window Run-Time Position dialog box.
Use Current Size ibool.png No

Returns the value of the Use Current Size checkbox in the Window Run-Time Position dialog box.

Remarks

The following table lists the characteristics of this method.

Short Name FP.Run-Time Pos.Get
Data type No return value
Available in Run-Time Engine Yes
Available in Real-Time Operating System No
Settable when the VI is running Yes
Loads the front panel into memory Yes
Need to authenticate before use No
Loads the block diagram into memory No
Remote access allowed Yes
Must wait until user interface is idle No
Available with control VIs No
Available with global VIs No
Available with strict type definitions No
Available with polymorphic VIs No