Gets or sets a descriptive area name for the LO alarm for a shared variable. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module.

Create alarm areas to acknowledge an entire area of alarms as a single batch operation.

Note You can enable alarming only for network-published shared variables.

This property is similar to the Area option on the Alarming page of the Shared Variable Properties dialog box.

Remarks

The following table lists the characteristics of this property.

Short Name Alarming.Lo.Area
Data type cstr.png
Permissions Read/Write
Available in Run-Time Engine No
Available in Real-Time Operating System No
Settable when the VI is running Yes
Loads the front panel into memory No
Need to authenticate before use No
Loads the block diagram into memory No
Remote access allowed Yes