Saves the LabVIEW project to the path that the project was previously saved to or loaded from or to a specified path.

If the project has not been saved and the value of the Path parameter is <Not A Path> or Path is unwired, this method returns an error. You also can select File»Save Project to save the project.

Note The LabVIEW Datalogging and Supervisory Control Module supports this method in the Run-Time Engine.

Parameters

Name Data type Required Description
Path cpath.png No

Path to the project.

Remarks

The following table lists the characteristics of this method.

Short Name Save
Data type No return value
Available in Run-Time Engine No
Available in Real-Time Operating System No
Settable when the VI is running No
Loads the front panel into memory No
Need to authenticate before use No
Loads the block diagram into memory No
Remote access allowed Yes