Gets or sets the depth of the flange that appears on the left end of a pipe network when you first place the Multi-Segment Pipe control on the front panel window.

The flange depth is the distance, in pixels, from the end of the adjoining pipe segment to the end of the flange. The maximum flange depth is 50 pixels. The minimum flange depth is four pixels. LabVIEW returns an error if you specify a value greater than the maximum or less than the minimum flange depth.

The following illustration shows the flange depth.

You also can set the flange depth interactively.

Remarks

The following table lists the characteristics of this property.

Short Name Flange1Depth
Data type cu32.png
Permissions Read/Write
Available in Run-Time Engine Yes
Available in Real-Time Operating System Yes
Settable when the VI is running Yes
Loads the front panel into memory No
Need to authenticate before use No
Loads the block diagram into memory No
Remote access allowed Yes