Sound and Vibration Software and LabVIEW Compatibility

Überblick

This page shows supported versions of NI Sound and Vibration Software, sometimes referred to as Sound and Vibration Measurement Suite (SVMS), or Sound and Vibration Toolkit (SVT) with LabVIEW development systems. Reference this information to ensure you install the correct toolkit version when upgrading or updating your system or software. Using incompatible versions may result in errors, or missing LabVIEW palettes or functions.

Note that this article replaces KnowledgeBase 6H3CTJOU: NI Sound and Vibration Software and LabVIEW Version Compatibility.  Some NI manuals may still reference the previous document. If you were redirected from the previous KnowledgeBase URL, please update your bookmarks accordingly.

 

Sound and Vibration Software and LabVIEW Compatibility

Beginning with LabVIEW 2010, NI Sound and Vibration software will only install and work with the corresponding version of LabVIEW. 

In the Downloads section at the bottom of this page, you can download a copy of this table, which may include older software versions.

Use this table to compare Sound and Vibration Software and LabVIEW Compatibility
Sound and Vibration Software Version LabVIEW Version
2020 2019 2018 2017 2016 2015 2014 2013 2012 2011
2020                  
2019                  
2018                  
2017                  
2016                  
2015                  
2014                  
2013                  
2012                  
2011                  


Note: NI Sound and Vibration Software versions 5.0 and 6.0 may be able to install on newer versions of LabVIEW. However, we recommend using the appropriate newer version of the software, as the older versions have not been tested and are not supported on newer releases of LabVIEW. If you do decide to use the older version of the NI Sound and Vibration software on a newer version of LabVIEW, be advised that you will need to mass compile your code after installing the new software.

Note: For all versions of NI Sound and Vibration, you will need to install NI-DAQmx in order to use NI hardware to perform data acquisition. For more information on which version of NI-DAQmx is compatible with your version of LabVIEW, see below.

Compatible