LabVIEW 2016 SoftMotion​模​块​补丁​详细​信息

LabVIEW 2016 SoftMotion​模​块​现有​2016 f2​补丁​发布。​建议​所有​LabVIEW 2016 SoftMotion​模​块​用户​安装​该​补丁。

也​可​通过​NI​更新​服务​获取​和​安装​该​补丁。​如​您​已经​安装​了​LabVIEW 2016 SoftMotion​模​块,​NI​更新​服务​将​使用​2016 f2​补丁​更新​您​已​安装​的​程序。​如​您​还​没有​安装​LabVIEW 2016 SoftMotion​模​块,​NI​更新​服务​将​使用​LabVIEW SoftMotion​模​块​2016 f2​安装​并​更新​程序。​LabVIEW SoftMotion​模​块​2016 f2​包含​LabVIEW 2016 SoftMotion​模​块​和​2016 f2​补丁。

LabVIEW SoftMotion Module 2016 f2​补丁​包含​f1​补丁​的​所有​改​动。​补丁​修正​了​下表​列出​的​问题。

LabVIEW SoftMotion​模​块​2016 f2​补丁​修正​的​问题

ID 说明
583192 SDI Axes do not implement the Smoothing attribute on reference moves
591142 SDI Axes do not have Home Switch Enabled by default or available in Axis Configuration dialog
607840 SoftMotion Drive Interface (SDI) VIs will not deploy when SoftMotion is not licensed
613626 Position Capture on SDI and UDV Axes do not handle position rollover
615087 SDI Axes can fault when changing move modes
632971 SDI Axes do not work after SoftMotion is re-​initialized
643434 SDI Axis position cannot be reset following a home move
667021 SoftMotion Set Plugin Mode will not properly close the SDI plug-​in if an error is input
618627 LabVIEW RT crash when running SoftMotion Axes at high Scan Engine rates
639822 LabVIEW RT crash when continuously calling property nodes on different resources in parallel


LabVIEW SoftMotion​模​块​2016 f1​补丁​修正​的​问题

ID 说明
602055 Wait Until Done VI completes execution before move is complete
600105 Position move setpoint can jump out of range on move start
601616 VxWorks RT Controllers do not work with SoftMotion Remote Axes
595072 Position Error resets without being commanded
602758 SoftMotion Help contains incorrect description when an axis in a coordinate is stopped
601614 Opening FPGA VI with SoftMotion FPGA IP always has a dependency conflict