Table Of Contents

Adjust Internal Reference Calibration (G Dataflow)

Last Modified: September 15, 2017

For the NI 5911, this function externally calibrates the internal reference. This function uses the external reference source instead of the internal reference source to calibrate the vertical range and offset. The internal source voltage is measured, and this value is stored and used for subsequent self-calibrations.

spd-note-note
Note  

Use this function only when following the NI 5911 Calibration Procedure (Start»Programs»National Instruments»NI-SCOPE»Documentation»Calibration).

connector_pane_image
datatype_icon

session in

The instrument handle that you obtain from Start Calibration. The handle identifies a particular instrument session.

datatype_icon

error in

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error error in contains an error
If no error occurred before the node runs, the node begins execution normally.

If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Default: No error

datatype_icon

option

Not defined.

datatype_icon

stimulus

The voltage of the applied DC signal.

datatype_icon

session out

Passes the instrument handle to the next node in the program. This parameter has the same value as session in.

datatype_icon

error out

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error error in contains an error
If no error occurred before the node runs, the node begins execution normally.

If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported

Web Server: Not supported in VIs that run in a web application


Recently Viewed Topics