Defines a user waveform for either standard function or frequency list output mode.
You must set the output mode input of Configure Output Mode to standard function or frequency list before calling this node. To select the waveform, set the waveform input of Configure Standard Waveform or Create Frequency List to user.
Name of the waveform generator channel that the node uses.
Handle that identifies your instrument session previously allocated by Initialize With Channels.
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.
Default: No error
Size of the waveform in samples.
Array of data you want to load into the new waveform.
You must normalize the data points in the array to be between -1.00 and +1.00. Use the amplitude input of Configure Standard Waveform to generate different output voltages.
Reference to your instrument session to wire to the next node.
Error information.
The node produces this output according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.
Where This Node Can Run:
Desktop OS: Windows
FPGA: Not supported