Table Of Contents

DAQmx Disconnect Terminals (G Dataflow)

Last Modified: January 11, 2018

Removes signal routes you created by using the DAQmx Connect Terminals node.

DAQmx Disconnect Terminals cannot remove task-based routes, such as those you create through timing and triggering configuration.

When this node runs, it immediately removes the route. This type of routing is called immediate routing.

connector_pane_image
datatype_icon

source terminal

source terminal specifies the originating terminal of the route. A DAQmx terminal constant lists all terminals available on devices installed in the system. You also can specify a source terminal by wiring a string that contains a terminal name.

datatype_icon

destination terminal

destination terminal specifies the receiving terminal of the route. A DAQmx terminal constant provides a list of all terminals available on devices installed in the system. You can also specify a destination terminal by wiring a string that contains a terminal name.

datatype_icon

error in

error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

datatype_icon

error out

error out contains error information. This output provides standard error out functionality.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application


Recently Viewed Topics