From 12:00 PM - 4:00 PM CST on Thursday, October 18, ni.com will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Table Of Contents

DAQmx Setup SC Express Calibration (4322) (G Dataflow)

Last Modified: September 18, 2017

Writes the specified value to the DAC on the specified physical channel(s) for an NI PXIe-4322. This device requires a sweep of values obtained from the calibration procedure.

connector_pane_image
datatype_icon

calHandle in

calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

datatype_icon

physical channels

physical channels specifies the physical channel(s) to calibrate.

datatype_icon

output type

output type specifies the type of measurement for the device.

Name Description
Voltage

Voltage generation.

Current

Current generation.

datatype_icon

output value

output value specifies value to write to the device, in the units of output type.

datatype_icon

error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

datatype_icon

calHandle out

calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

datatype_icon

error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application


Recently Viewed Topics