Table Of Contents

DAQmx Adjust DSA Calibration (Analog Output » Timebase) (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Adjusts the external calibration constants for the timebase of a DSA device with an adjustable oscillator.

    You must first call the DAQmx Setup DSA AO Timebase Calibration node and measure the frequency of the resulting sine wave. Repeat this process until calibration complete returns true.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    measured frequency

    measured frequency specifies the measured frequency of the sine wave generated by the device.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    calibration complete

    calibration complete returns TRUE if calibration of the device is complete. If this parameter returns FALSE, repeat the calibration process.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics